Overheating/Pressure build up problen

The Mad Hat Man · Oct 10, 2012

True, but one has to way against that the number of V6's to 1.8's and also when it goes its a 50% bigger problem.

What Dd says. Get the system bled properly.

teddywood1 · Oct 10, 2012

when you think you have filled it up properly then think again take the small tube of the expansion tank and blow down it this will release the valve and you will see your water drop then fill it up hope this helps

WLJayne · Oct 10, 2012

There is one bleed screw on the heater matrix hose and one on the coolant rail which is on the passenger's side of the engine.

Also loosen the c clip on the jiggle valve and pull it off the inlet manifold, then blow down it using a tube or a tight seal with your fingers - this will budge the jiggler if it is jammed . Careful though as you might get a gob full of coolant when you do.

Diesel Do · Oct 10, 2012

gforcegraham said:
Hi DD 2 bleed points? only used the 1 on the heater pipe

Graham

There's an 8 mm bolt in the steel pipe which runs along the back of the engine then turns 90 degrees and goes over the bell housing! It's in the bit over the bell housing!

DD

Overheating/Pressure build up problen

The Mad Hat Man

Well-Known Member

teddywood1

Well-Known Member

WLJayne

Well-Known Member

Diesel Do

Well-Known Member

Similar threads