I`m having a few problems fitting the overdrive to my series 1 (2litre 1954) ....I can`t get it to fit home properly it is protruding approx 10mm....I`ve tried spinning the engine whilst pulling back on the overdrive lever to no avail..........any ideas would be greatly appreciated
overdrive fitting problem
- Thread starter loupus666
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ya may be better askin on this place LR4x4 - The Land Rover Forum (Powered by Invision Power Board) we'r all a bit numb on ere parently ... 
