Disco 2 New tyres.... lots of noise....

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
T

tilly2

Well-Known Member
Posts
1,192
Location
Stafford
Had a full set of Grabber AT3's fitted last week. Previously the rear two were Grabbers, and the fronts were an unknown make. But, jesus, the noise levels have rocketed in the cab.. Sounds like bad bearings now.

Anyone else fitted AT3 tyres and experienced the same...
 
A lot of it will depend on what the previous patterns were. General Grabbers are made in H/T, A/T and M/T patterns. If your previous tyres were highway terrain, then it's natural fitting an all terrain tyre is going to generate more noise.
Also, a new A/T tyre with around 10mm of tread will be louder than a worn tyre (H/T or A/T).
 
Fair enough, I need the off road capability to drive to my field, and round where I live.... Had a new set of Yokohama Geolanders on my Rav4 and they werent this loud...
 
Its always the trade I'm afraid. The more aggressive the tread pattern, the louder they get. Compounds can also affect the road noise, it may be the Grabber's have a higher cut resistance compared to the Geolander too. From what I'm told, the new A/T3 is a pretty good tyre.
 
Hmmm, just took it out for a long run... I'm beginning to wonder if its a wheel bearing, or the diff making the noise... Tyre noise is one thing, but this is quite loud.
 
Well, Craddocks called today.... New bearing retaining bolts, and hub nuts have arrived. Front wheel bearings and diff seals will be the first to try... I've replaced the oil in the front diff a month ago, so cant be that.. it was thick and brown though. Should also be a new front diff breather pipe with the kit, as I discovered mine has worn through. Been some floods here lately, so water might have got into the diff again. Replacements on the Bay for around 75 quid, so no major worries...
 
Im going to change the bearings, as I suspect they need doing anyway. Ive drained and changed the diff oil already, which was all dark and gloopy. Seals need doing at the same time, but I've only bought some Britpart ones. Road noise is slowly decreasing, although I think Im just getting used to it...
 
We had 4 new General at3s the other day on an Isuzu, drive it 300 miles after, just as quiet as Bridgestone h/ts. 245/70/16. Maybe tracking is out and its sitting on the edges at the front creating a howl.
 
I had an ABS light on today, so suspect a bearing issue. Nanocom out with a mate, so will check which one when its back.
 
You must log in or register to reply here.

Similar threads

Hammer'n'tongs
Tyres wearing unevenly:- Axle ends out of alignment
Replies
9
Views
1K
Hammer'n'tongs
Hammer'n'tongs
S
1988 90 replacing lights with LEDs and have lots of questions
Replies
5
Views
902
sleepybear
S
D
L320 TDV6 multiple issues at once with power drop
2 3
Replies
43
Views
4K
Graculus
Graculus
N
Rear diff issues
Replies
5
Views
844
niko-h
N
A1EK
Pulsating sound suspect wheel bearing or worse?
2
Replies
21
Views
3K
Anaconda
A
Back
Top