new rear crankshaft oil seal

Eyup. Just registered. I'm going to fit a new rear crankshaft oil seal. Its a 1954 rover p4 60 engine but down there just the same as the 2l ioc. Hear tell its a bit tricky. Any tips would be much appreciated. Thanks

longshanks, longshanks is it? al tell you this boy! ave only wan thing tae say to you.





FREEDOM!!!!


and i'll consult the book off vast knowledge to see if it say owt abart yer injun

Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace Wallace WWWWAAAALLLLLLLAAAACCCE

Uniter of Kingdoms-owner of leaky landy

reet me book dunt do yours, but the 2ltr is fairly straight forward, if you want a detailed write up yule have to wait till after me dinner.
in short drop bearing cap, hook oot the out seal and apply lots of lub to the new one, and slide it in ,refit cap ensuring you dint nip the seal.
there's a load of spurge about using moly poly di helium oxide to lub the thing but a good doosing in injun oil should do

is there summink about not pinching it? how and on what might it pinch i wonder?