300bhp/ton
Well-Known Member
- Posts
- 5,029
- Location
- Near MK
Any tips or pointers on good ways to change these? Access looks pretty horrendous. Got new plugs, leads and coil packs ready to go on.
P38A New coil packs - Thor V8?
- Thread starter 300bhp/ton
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,912
- Location
- North Shropshire
They do come out through the gap on the RHS, easier if you can get the leads off first.
It's a bit of a wiggle and make sure you have plasters at the ready
It's a bit of a wiggle and make sure you have plasters at the ready
- Posts
- 33,912
- Location
- North Shropshire
Mine has had part of the backing plate cut away so there's only one (right hand) bolt holding it in place. Wonder if that helps...
Henry_b
Think outside, no box required.
- Posts
- 15,509
- Location
- somewhere else
I pull the upper intake off makes life easier especially if you have large hands.
If you have woman hands it might be slightly easier.
If you have woman hands it might be slightly easier.
JUKE179r
Well-Known Member
- Posts
- 3,166
- Location
- Suffolkshire
If you have SAI plumbing like I do on my Disco 2 it’s a PITA! The intake manifold will have to be removed to replace the packs.
Just follow what @kermit_rr mentioned and you can’t go wrong.
Just follow what @kermit_rr mentioned and you can’t go wrong.
Last edited:
biketeacherdave
Well-Known Member
- Posts
- 4,893
- Location
- south east london
Pull the intake manifold off, your gonna hate your self if you don't and you get those leads in the wrong place
- Posts
- 33,912
- Location
- North Shropshire
I could probably do it with my eyes closed now!! Though probably wouldn't make much difference as you can't see buggerall anyways!!
Not put them on wrong yet, getting them off is the hard part
300bhp/ton
Well-Known Member
- Posts
- 5,029
- Location
- Near MK
Thanks. Probably a job for next weekend, putting an engine in my brothers 90 this weekend and need to get it running first.
Gord Wedman
Well-Known Member
- Posts
- 617
- Location
- Chilliwack, British Columbia
I would recommend tagging all the plug wires and making a diagram showing where they go.
Had a devil of a time getting them right when I changed my packs.
Had a devil of a time getting them right when I changed my packs.
- Posts
- 33,912
- Location
- North Shropshire
JUKE179r
Well-Known Member
- Posts
- 3,166
- Location
- Suffolkshire
Laying out my coil pack in real-time…
- Posts
- 3,957
- Location
- Near Heathrow.
No.5 needs an insulating cap ?
- Posts
- 33,912
- Location
- North Shropshire
Good spot
JUKE179r
Well-Known Member
- Posts
- 3,166
- Location
- Suffolkshire
Yep. This pic was from last year when the boot ripped while making the HT leads and lining them up for installation.
