Badassbrother
New Member
- Posts
- 3
My full beams are bringing on brake lights along with fog light and full beam, dipped beam isn’t doing anything, need help urgently as I’m dying to fix it
Need electrical help
- Thread starter Badassbrother
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
steve2286w
Well-Known Member
- Posts
- 5,122
- Location
- monkeyangerland
Redo the earths should help
- Posts
- 37,530
- Location
- North Shropshire
If in doubt, check the earth's
Badassbrother
New Member
- Posts
- 3
Will it make a difference as I haven’t done anything to the earths, my front left indicator wasn’t working so I wired it in with the back left and then my problems started?
steve2286w
Well-Known Member
- Posts
- 5,122
- Location
- monkeyangerland
Where various lights come on unexpectedly I’ve found it’s poor earths, If you have the wiring diagram , the colours very simple to identify so it would have been either live or negative issue . So remaking the earths around the front grille always a good start, both front and rear left indicators 12v are green/red and come from the same feed before splitting to front and back so work from there towards front indicator and it will be poor 12v wire/connection or earth not working
Dorset_dumpling
Well-Known Member
- Posts
- 1,024
- Location
- Poole, UK
- Posts
- 37,530
- Location
- North Shropshire
yes
why wasn't it working? probably earth
if you disconnect it again does the problem go away? I bet it does
Scalleys Dad
Active Member
- Posts
- 106
- Location
- Exeter, Devon
Having spent a few hours scrambling around underneath mine and some awkward nooks and crannies I found, mostly for my sanity, that a bit of blue or green masking tape wrapped around or just stuck on all the terminals or connections I had checked stopped me from utterly confusing myself. If you do find yourself scrambling about down below be armed with a rag, a toothbrush, WD40, aforementioned tape, a sharpie pen and a small torch………….. that flippin works.
Badassbrother
New Member
- Posts
- 3
Where are the best places to look
tottot
Well-Known Member
- Posts
- 8,512
- Location
- west wales coast
See the black arrow head symbols in @Dorset_dumpling's diagram above ? They are the earth points and will be on the body, chassis or engine near the item they are earthing.
Scalleys Dad
Active Member
- Posts
- 106
- Location
- Exeter, Devon
As Tottot says follow the diagram above. If you can print it off it helps but if you keep a systematic approach ticking over in your head and start with the big boys, (battery/alternator/starter), use the masking tape or sharpie pen idea to track where you have already been it gets easier. I found three joins that were just hanging in there and the wire and spade connector for the oil pressure light had parted company so get some crimping practice in then do it for real.
Scalleys Dad
Active Member
- Posts
- 106
- Location
- Exeter, Devon
It’s amazing what you find when you are forced to look hard. I have a tow bar and fittings but I am sure there are no wires. Dammit now I’ll have to check.
When I was scrambling underneath her last week I found an old earth lead still neatly connected to the underside of the engine block but the other end had disappeared long ago. I might investigate it further but a week since the last shenanigans I have 12.6/12.7 from the new,new battery when standing and 14+ when she fires up. I am going for it tomorrow and we are off on a jolly across the wilds of Devon, obviously not that wild as retaining a phone signal will be factored in.
She is booked in to go up on a ramp in August, bookings are gold dust these days, so a lot more probing and checking to do then. I know we don’t need an MoT these days but I do like to feel like a responsible adult at times.
