My Disco 1 Work in Progress.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Busy day tomorrow. Got it back up & running tonight.

So tomorrow I will be fitting the safari snorkel, my winch turned up today and new winch bumper will be here Tuesday. Also going to G3 the full thing after I've gone round it with the power washer and used TFR all over.

Back lights will be replaced with the factory items and that's about it.

Will update with pictures
 
Been an eventful week. Disco has had a new engine fitted. Safari snorkel all fitted properly.
Standard back lights fitted. I also found a massive vibration through the handbrake caliper bracket. So removed and trimmed it down. All good now. Also gave the engine bay a good clean all over and tidied up some wiring.









New spare wheel & tyre sorted too. Just need standard bumper lights.
 
Old man emu. With 2 inch spacers.

It was underpowered. Took head of and valve burnt out, bottom end was worn. Turbo was tossed too. Works out easier just to fit a new engine.
 
Fair enough. Don't know why u didnt buy a standard disco for a bag of sand and done it yourself coz you've completely changed this one.
 
All I've done is fit a snorkel and winch bumper.

It wasn't the work. This has the radius arms. The good suspension. It had bits on I knew I could sell.

Boost alloys gone for £350 spacers £90 rear lights and old snorkel £100 bumper £100

So it would of been a £1300 disco until it turned out the engine was ####ed so I've had to put £500 into a new engine. Otherwise it'd of been cheap.
 
Back
Top