MAF Sensors issue 2010 V8 3.6

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Garwillis

Garwillis

Active Member
Posts
157
Location
Green Hilly area of Wales
Afternoon all I seem to have picked up a MAF sensor fault on my 2010 3.6 V8 RR ..the code comes up as Mass / Volume air flow B - circuit low
I've removed them and cleaned them with electro clean but to no avail, question is which one is B ? I've attached the readings ..
20190126_122817.jpg
[/GALLERY]
 
Garwillis said:
So after fitting a new MAF problem still there now just showing P007F air flow problem bank 1+2 correlation !!! Not great ..and So it goes on .....
Click to expand...

Only thing i can think of in relation to that is that one MAF is showing a different flow rate than the other. Maybe you have an EGR valve stuck slightly open. Or an air leak after the MAF sensor.
 
Well at least it has a positive side. All those who did not have a bloody clue what was wrong, can now come on if it happens again in the future to anyone else, and claim they are clever and know the answer. :D:D
 
Last edited:
You must log in or register to reply here.

Similar threads

P
L322 Vogue 2006 4.4 V8 MAF/limp mode issues
Replies
9
Views
807
peterself
P
MAF Diver
Disco 2 Rough idle in a V8 D2a — tried MAF, O2, sparks, leads
2
Replies
35
Views
3K
marjon
marjon
JokerUK
Sport MAP/MAPT Sensors on 4.2 S/C
Replies
0
Views
891
JokerUK
JokerUK
M
Discovery 4 - Limp Mode Cold Start Manifold absolute pressure issues
Replies
2
Views
2K
Graculus
Graculus
Ashs1
D2 v8
Replies
11
Views
1K
sierrafery
sierrafery
Back
Top