LT77 Gearbox Problem

Danmids · May 28, 2009

I was approaching a roundabout the other day and as I came down the gears couldn't select anything. After about 10 seconds of frantic wiggling I managed to get first but took a lot of 'persuasion'. I seemed to be able to change ok after that, although seemed 'notchy' on each change. I was also doubling the clutch, not sure if it helped or not. Do you think I've got a problem with the selector / linkage or is a new box the likely cure? All advice greatly appreciated oh wise ones.

Danmids · May 28, 2009

I forgot to add. It appeared to be trying to 'drive' a bit even with the clutch pedal fully down.

Beast o Bodmin · May 28, 2009

****ed.
Take out and replace moveing parts like clutch,slave,pop in new bearing and replace arm too.Iannotts can supply parts ok...
axletwister.co.uk me finks

ratty · May 28, 2009

It does sound like a clutch hydraulic fault. Could also be thrust bearing (although I'd expect a lot of noise) or clutch arm wearing through.

Beast o Bodmin said:
****ed.
Take out and replace moveing parts like clutch,slave,pop in new bearing and replace arm too.Iannotts can supply parts ok...
axletwister.co.uk me finks

You on commision or summit?

Shifty1962 · May 28, 2009

My moneys on the clutch.

iannotts · May 28, 2009

Beast o Bodmin said:
****ed.
Take out and replace moveing parts like clutch,slave,pop in new bearing and replace arm too.Iannotts can supply parts ok...
axletwister.co.uk me finks

:nospamhere:

:doh:

LT77 Gearbox Problem

Danmids

New Member

Danmids

New Member

Beast o Bodmin

Banned

ratty

I'm not special I'm limited edition

Shifty1962

Well-Known Member

iannotts

New Member

Similar threads