LR time D3 timing pin

Has anyone got the schematics for the timing pin? as seen on lr time presuming it's a Ford pin? Used at factory? Was going to work it out on my next build when fitting crank but could do with it now presume it's a longer version of what I took out of the hole see pic

Looking good mate , is this what ur looking for , hope it helps as it also lists the special tools part numbers as a reference

Know u can get a non genuine set but found the genuine web site in case it’s useful to u

Sorry, Can’t find the actual dimensions

External diameter 5.7mm & 7.5mm

Cross ref chart

Also wonder if u can use the tail end of a drill bit to give u the size in mm

hope it’s useful to u mate

Hi mate thanks for the response just a little project trying to make the timing pin that screws into the block as made by Christian on lr time the one that locks the crank I think I may have sussed it it seems the blank plug in pic is the same diameter 7mm as Christians but is cut down version I found his schematics it needs to be 79.2mm long this creates a stop for the crank once again many thank will let you know how I get on