L322 2010 v8 3.6 suspension fault yellow triangle lanp showing. Its been like this 6 months but there seems to be nothing wrong with the suspension, it works at all three hieghts, my local garages test equipment wont work on RR,s. Can I get software for my laptop and a OBD2 cable that will sort it. Very much a novice, had never even heard of OBD2 until a few minutes ago reading these pages. Thanks
L322 suspension fault light
- Thread starter Johnviper
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Welcome 
.
SDD will work on a laptop. How much it does I dont know. there is a thread on here about it if you search.
But there is dedicated stuff you could consider all be it perhaps a bit more money.
If you are getting a warning something isn't right, so best get it sorted before it leaves you on the bump stops cos that's a rough ride.
J
.SDD will work on a laptop. How much it does I dont know. there is a thread on here about it if you search.
But there is dedicated stuff you could consider all be it perhaps a bit more money.
If you are getting a warning something isn't right, so best get it sorted before it leaves you on the bump stops cos that's a rough ride.
J
1988smithy
Well-Known Member
- Posts
- 3,899
- Location
- West midlands
Whereabouts are you mate, there may be someone nearby with diagnostics willing to pull any codes for you
Sheffield S8 8QE, this is all magic to me, we used to clean the spark plugs, adjust the point gap spray everything with wd40 and you were away. As I am sure you have guessed Im an old codger, but have owned land rovers since I was 18, had just about everyone ever made, they used to be easy to work on but now I look under the bonnet and don't recognise anything. Would be very grateful if I could pay someone nearby to analyse this fault, and thanks for the reply.
L322 2910 V8 3.6 So I have bought a cheap motopower obd2 reader scanner from amazon, the first thing it says in the book is turn the ignition off. How do I do that, I dont have an ignition key, I have no idea how to turn it off or on, I dont know it its on, or off. Any ideas very welcome.
1988smithy
Well-Known Member
- Posts
- 3,899
- Location
- West midlands
Just unlock, get in and plug your reader in. Then click scan codes and it will probably prompt you to turn ignition on, just one press of the start button I think
@kermit_rr has a 2010 l322, he can advise for sure
When you open the car it wakes up, don’t think it turns ignition on till you press the button and will only start with the brake pedal pushed.
I personally wouldn’t expect too much from that reader, but we maybe surprised.
J
- Posts
- 31,414
- Location
- North Shropshire
Mines a 2012, but yes, ignition on, press button without foot on brake. Turn it off by pressing again, also without foot on brakeJust unlock, get in and plug your reader in. Then click scan codes and it will probably prompt you to turn ignition on, just one press of the start button I think
@kermit_rr has a 2010 l322, he can advise for sure
