micknkatenki
Active Member
- Posts
- 438
- Location
- Lincolnshire
Hi, 2006, TD6 model, am trying to find the torque setting for the rear diff, front pinion nut. Can find other torque settings just not for the rear diff. Thanks.
L322 rear diff
- Thread starter micknkatenki
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
Is it in Rave manual , a 2006 TD6 is a change over model so you might have a mix of JLR and BMW?
micknkatenki
Active Member
- Posts
- 438
- Location
- Lincolnshire
In all the torque settings I've found this one isn't there, typical, and yes its a BMW diff 4.10.
Front pinion nuts are normally torqued to a set bearing pre-load, which is difficult to measure without the diff being on the bench. The correct way to reset the pinion nut, is to mark the fitted position, then count how many rotations it takes to remove it. Then you count the same number of turns back on, pulling the nut back to the mark previously made.
micknkatenki
Active Member
- Posts
- 438
- Location
- Lincolnshire
Front pinion nuts are normally torqued to a set bearing pre-load, which is difficult to measure without the diff being on the bench. The correct way to reset the pinion nut, is to mark the fitted position, then count how many rotations it takes to remove it. Then you count the same number of turns back on, pulling the nut back to the mark previously made.
Thanks, Diff is out and on the bench, I thought it was a torque setting, I marked the spline to be able to fit back in the right place but didn't think about marking for rotations for refitting the nut....... doh. have since been told that the torque setting is 180nm. fingers crossed.....
