inlet manifold
- Thread starter tincan
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Chaser
New Member
- Posts
- 2,175
Tighten using common sense or if you have a small torque wrench use the info below..
Refit
1. Clean inlet manifold and mating faces.
2. Clean EGR pipe flange and EGR valve mating
face.
3. Fit new gaskets to inlet manifold.
4. Fit inlet manifold and tighten fixings evenly.
Tighten M6 bolts to 10 Nm (7.5 lbf.ft)and M7
bolt and nuts to 15 Nm (11 lbf.ft).
5. Fit grommet to inlet manifold.
6. Connect multiplug to turbocharger boost
pressure sensor.
7. Fit fuel return hose and harness to clips on inlet
manifold.
8. Fit EGR pipe clamp and tighten screw to 10 Nm
(7.5 lbf.ft).
9. Connect vacuum hose to EGR valve.
10. Fit intake ducting assembly.
Refit
1. Clean inlet manifold and mating faces.
2. Clean EGR pipe flange and EGR valve mating
face.
3. Fit new gaskets to inlet manifold.
4. Fit inlet manifold and tighten fixings evenly.
Tighten M6 bolts to 10 Nm (7.5 lbf.ft)and M7
bolt and nuts to 15 Nm (11 lbf.ft).
5. Fit grommet to inlet manifold.
6. Connect multiplug to turbocharger boost
pressure sensor.
7. Fit fuel return hose and harness to clips on inlet
manifold.
8. Fit EGR pipe clamp and tighten screw to 10 Nm
(7.5 lbf.ft).
9. Connect vacuum hose to EGR valve.
10. Fit intake ducting assembly.
