i real need help now

hi i need help real bad now i just put new push rods in and the head gacket went . i have fitted new 1 and i bleed it but want fire ever thing there diesel there and golw pulgs work just want file so plesas help me thank

help just but new push rods in and new head gacket want fire up now got flue just want run

When your engine spins on the starter does it sound normal?

So let me get this straight: you changed your push rods (why) then your HG blew? So you replaced it now it won't start?

hi i chang them because the cambelt jump and it bent the push rods and then the head went so but new head gazit on it and the it sound good turn over just wont fire diesel there i buging me now lol

Are your sure the timing is set up right? Have you adjusted the tappets after doing the head?

AS richard said +check the stop sloeniod is ok and diesel is getting through????....dave

landrover russ said:

hi i chang them because the cambelt jump and it bent the push rods

Click to expand...

Right, remember I asked if it sounds normal when you turn it over on the starter? Reason I asked was I suspected you may have a timing issue or snapped belt. If it jumped a tooth surely you sorted the timing issues and fitted a new belt before putting in new push rods?

I reckon this is timing related and your new push rods might be damaged now if you didn't sort the timing.

hi there the tap r right and sound ok turn over the diesel there at the injeter and just wont fire

hi there i did do the timing and it spot on and engine soung fine turning over and it at the injeter all 4 of them just wont fire up was thing of tow it to get the presser up

When it turns over on the starter, do you get white smoke?

no there no smoke it clerl just wont fire

Do you have power at the heater plugs?, you could wire them direct to the battery to prove they are on, but dont leave them too long.