I'm just refitting a new inner hub oil seal and even though it's at the required 4mm depth the lip protrudes slightly beyond the top of the hub whereas the old seal has a shorter lip. Is this correct? It's an OEM part FTC4785 (the same code is on the old seal) going into a K-reg Defender 90 rear axle.
Hub bearing oil seal depth
- Thread starter Resurgam
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,073
- Location
- west wales coast
The inner lip is a dust/mud shield, your old one may well have worn some.
Thanks. It's all fitted now so time will tell if it's right or not!
Similar threads
