How to remove the Roller boot cover???
- Thread starter feargunna
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Guys, does anyone know how to remove the boot roller cover from a Freelander Stationwagon TD4???
I don't have the original manual and can't find it in the Haynes manual:doh:
A little help.........please!!!
push it to one side or push both ends in and lift
Mantamad
New Member
- Posts
- 1,067
- Location
- Fife Scotland
As above the ends are spring loaded and push inward, after it unclips you then have the Kripton Factor type puzzle of how to get it out as it seems too wide for the car!
ertin
New Member
- Posts
- 53
- Location
- Colchester, Essex.
You don't need to do that. Release the RHS (looking from the back of the tailgate door), lift up wards slightly releasing the LHS, pull the RHS to the rear and drop this end down the space above the rear interior light. Continue dropping this side down wards (leaving the LHS where it is) then guide the RHS out of the tailgate door. Reverse the procedure to install it.
Works a treat! Eric.
Davec
New Member
- Posts
- 2,131
Unless you have a toolbox or similar in the back getting in the way!
I've tried most ways and found mine easiest, but it's probably down to personnel preference.
I normally only remove it if I am folding the seats anyway, and I store it on the floor in front of the back seats, so it has to go one way through the side door anyway.
I've tried most ways and found mine easiest, but it's probably down to personnel preference.
I normally only remove it if I am folding the seats anyway, and I store it on the floor in front of the back seats, so it has to go one way through the side door anyway.
ertin
New Member
- Posts
- 53
- Location
- Colchester, Essex.
Ah yes! I see that could be a problem! I usually remove mine when the load area is empty and store it in the garage, then put it back when I have finished. It just goes to show how versatile the Freelander can be.
Similar threads
Freelander 1
Gear stick cover. Help
