Plenty of walkthroughs on how to replace the front output shaft seal. None (that I can find) mention the depth to which the seal should be driven into the box. I'm guessing that means you drive it all the way in until it seats, but I really don't want to find out the hard way that I'm wrong! Can anyone confirm?
How far in do you push the LT230 front output shaft seal?
- Thread starter thetim
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
its not critical as long as its not flush with the outside edge or pushed right back till it touches bearing,5mm in its not bad
