Hey all from braunston, Northamptonshire

TheMuffinRanger · Jun 22, 2019

Hi,
The names Jim and I'm the proud owner of a 2 wheel drive 2001 Freelander s as the previous owner decided to remove rather than replace the propshafts so looking for a complete assembly if anyone knows of any going haha found one on eBay ordering next week any recommendations on must does for light green Laning all year round would be nice look forward to learning about this new addiction of mine haha

Newinnwoodman · Jun 22, 2019

Welcome 2wd Jim. You name it someone on here has done it , twice !

gold rover · Jun 22, 2019

TheMuffinRanger said:
Hi,
The names Jim and I'm the proud owner of a 2 wheel drive 2001 Freelander s as the previous owner decided to remove rather than replace the propshafts so looking for a complete assembly if anyone knows of any going haha found one on eBay ordering next week any recommendations on must does for light green Laning all year round would be nice look forward to learning about this new addiction of mine haha

Welcome
If you've found one, just buy it. Mainly because you cannot buy, sell, or subtly , pretend you are not doing either, onnthis site, unless you have 50 constructive posts.
Once you have it, I am sure there will lots of help and advice in the dedicated Freelander section.

RangeRoller dt · Jun 22, 2019

2WD Jim is a good name, I will call you that from now

Not uncommon for shafts to be removed, okay short term.

Welcome to LandyZone

blue beasty · Jun 22, 2019

RangeRoller dt said:
2WD Jim is a good name, I will call you that from now

Not uncommon for shafts to be removed by PO’s. Usually rear diff pin problems.

Welcome to LandyZone

Rear diff pin??

The reason there are so many 2wd Freelanders is VCU problems.

RangeRoller dt · Jun 22, 2019

Thought rear pin was weak point for FL’s?
VCU not cheap

TheMuffinRanger · Jun 23, 2019

Cheers guys luckily I've found a freelander with a seized engine localish to me can't pick it up till next week tho but I'm hoping just to swap the whole prop assembly, I was told they did it cause the carrier bearings went I assume they meant the vcu, they took the whole lot off so that's why I thought get a donor in the end my ones to nice to strip it's worth saving imo

RangeRoller dt · Jun 23, 2019

Donor is good option, check the vcu on donor before picking it up, there’s bound to be a check in the FL forum search bar

Hippo · Jun 23, 2019

Welcome to the forum

Hey all from braunston, Northamptonshire

TheMuffinRanger

New Member

Newinnwoodman

Active Member

gold rover

Well-Known Member

RangeRoller dt

Well-Sprung Member

blue beasty

Leaks an prone to bits dropping off

RangeRoller dt

Well-Sprung Member

TheMuffinRanger

New Member

RangeRoller dt

Well-Sprung Member

Hippo

Lord Hippo

Similar threads