HELP !! Welder needed Newcastle area ?

mobileman · Oct 23, 2011

Lo all,

my 300 tdi disco has failed MOT

Looking for a welder to work on land rover discovery 3dr 300 tdi needs some welding to pass MOT, mates garage to busy at moment but need done ASAP, anyone recommend pref experienced in landys ?

newcastle upon tyne area, can be viewed on the ramps and have a list of work

Or anyone want to buy for spares/repair/off roading

Dr_evil · Oct 23, 2011

I'm nearby ish, how much needs doing ?

Bump · Oct 23, 2011

mobileman said:
Or anyone want to buy for spares/repair/off roading

Sure, i'll start the bidding at £100.

Dr_evil · Oct 23, 2011

If we're bidding I'll offer 2 mars bars, a bag of chips and half a tango

mobileman · Oct 23, 2011

Dr_evil said:
I'm nearby ish, how much needs doing ?

needs drivers side inner arch, boot mounts, drivers side rear body mount and patching on drivers side chassis leg about 2 days welding my friend garage saying but can be viewed if needed

mobileman · Oct 23, 2011

Bump said:
Sure, i'll start the bidding at £100.

rather keep her TBH but if sell i'll bare that in mind

Dr_evil · Oct 23, 2011

mobileman said:
needs drivers side inner arch, boot mounts, drivers side rear body mount and patching on drivers side chassis leg about 2 days welding my friend garage saying but can be viewed if needed

Mmmmm do I feel like 2 days in newcastle

mobileman · Oct 23, 2011

Dr_evil said:
Mmmmm do I feel like 2 days in newcastle

where you based ? could possibly put on trailer if your intrested ?

Dr_evil · Oct 23, 2011

Near-ish may have been stretching it, thought I was a bit closer but just checked the map

I'm 90 miles west from you, could still possibly do it though

mobileman · Oct 23, 2011

Dr_evil said:
Near-ish may have been stretching it, thought I was a bit closer but just checked the map

I'm 90 miles west from you, could still possibly do it though

ok thanks, will see if anyone closer, would you pm me on your daily rate ?

lil_me · Oct 24, 2011

Sent you a message

Oldseadog · Oct 24, 2011

Is it stripped ready to weld, or does it need prepping?

OSD

zzr1200 · Oct 25, 2011

Dr_evil said:
If we're bidding I'll offer 2 mars bars, a bag of chips and half a tango

mobileman said:
ok thanks, will see if anyone closer, would you pm me on your daily rate ?

1 mars bar and half a tango......

HELP !! Welder needed Newcastle area ?

mobileman

Member

Dr_evil

Banned

Bump

Well-Known Member

Dr_evil

Banned

mobileman

Member

mobileman

Member

Dr_evil

Banned

mobileman

Member

Dr_evil

Banned

mobileman

Member

lil_me

Active Member

Oldseadog

Well-Known Member

zzr1200

Well-Known Member

Similar threads