Help...... Doors locked Cant get eka code working!

Hi,

Can anyone help me with this problem I think I have a super lock, the dash reads engine disabled, when key is turned it says press remote, when I press the remote nothing happens??
I have tried entering the eka code several times but nothing happens apart from the indicators flashing when I turn the key clockwise?

The drivers window is half down so I have access to the ignition but not doors will unlock?

Any help will be greatly appreciated

regards

Lewis

go to rear window drivers side and press your remote if that dont work, are you putting your eka code in after you turn it to lock 4 times?

Hi J,
Just tried the remote by the back window nothing happened, I have been to lock position 4 times before starting the code.
lock is clockwise?

i have just sent you pm. as you lookat door you turn to left 4 times then start eka to the right you must do all this in one movement does not allways go first time keep trying

Hi J,

Just got the message, had a go but no joy, the indicators still flash when I turn the key to lock. when the key turns to lock I hear a click but nothing when it turns to unlock, could that be a problem? and lastly do I need to leave a certain time gap between trying the code?

Thank you for you help J I hope I can get this sorted, Im in Birmingham so there are a few guys round to help.

when i do mine i get flash with the 4 locks then nothink till the last when i open it lots of guys off here round by you. start new thead and ask if anybody would come round and give you a bit of help, pity you not closer to me i would have come round and sorted for you. j

try dismantling the drivers door lock, reassemble. Then try eka

gavbriggs said:

try dismantling the drivers door lock, reassemble. Then try eka

Click to expand...

cheers gav, will have a look tomorrow, not sure I I can dismantle it from outside the car but will try.

Thanks for the help guys, fingers crossed i get it sorted.

regards

Lewis

I had exactly the same problem but I was completely locked out. AA had to prise door open and use wire to pop the lock. The problem was the linkage at the back of the drivers door handle had come loose - reconnected and everything was ok.

David

Are all the door handles closed properly ? If not that'll stop the EKA for working, Also I only lock twice before entering the code.

Good Luck

Steve

j the range said:

when i do mine i get flash with the 4 locks then nothink till the last when i open it lots of guys off here round by you. start new thead and ask if anybody would come round and give you a bit of help, pity you not closer to me i would have come round and sorted for you. j

Click to expand...

Hi J,
Thanks for the help the other night managed to get the car sorted today with the key, it was the lock that was causing the problem, ive wd40ed the barrel and connecting rods and it seems to be working fine, just been tryi ng to sync the remote but not having any joy.

Thanks again

Lewis

have a look at other threa: