heating problems 1999 p38 4.6
- Thread starter sharjah
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 16,475
3 blend motors - 1 for distribution and two for the temps (one on drivers side and one on passenger side)
thanks for reply,will start on the passenger side,should be the easiest!
- Posts
- 16,475
The thre motors are all spliced into one loom....
If replacing just the one motor, you'll need to cut the wires to it and rejoin/splice the new motot into the original loom.
If replacing just the one motor, you'll need to cut the wires to it and rejoin/splice the new motot into the original loom.
- Posts
- 58,170
- Location
- Preston Lancs.
Unless you cut the wires and reconnect the new motor or disconnect the pins for that motor from the multi plug, you cannot change blend motors individually.
- Posts
- 16,475
Morning Tony, I hope this missive finds you in rude health.
Thats kind of what I said, only yours doesn't have spelling mistakes!!!
- Posts
- 58,170
- Location
- Preston Lancs.
Morning Ant. Didn't see your post. Not bad today. Have you bought the little fella any spanners yet?
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
Hahaha you funny !
When land rover built the P38 they started with the blend motors.....
... then built the rest of the car around them
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
Set of Kamasa was in the baby shower gifts !
