Head Gasket gone - guide on price?

B

britbadboy

New Member

Posts

25

• Apr 24, 2009

• #1

Hi Guys,

the inevitable has happened lolll... its gone along with a piston burn out! So been quoted about 800 quid by garage... is dat ok price to pay fr head gasket problem?

Sorry to ask but am totally naive ... need help bigggg time!

 

howardo

New Member

Posts

6,783

Location

In the woods

• Apr 24, 2009

• #2

I am assuming that you have the petrol engine, if it is fixed it will more than likely fail again in around 30K. It all depends on the value of your freelander. It may not be worth it. You could break it for spares and buy a cheap second hand l-series diesel freelander instead. Should find one with an MOT for about a grand to £1500.

 

B

Beast o Bodmin

Banned

Posts

17,157

Location

never did like the welsh.....tom jones is also cra

• Apr 24, 2009

• #3

I can fix it for £200....

However you will need to deliver it and buy an autotrader and train ticket home

 

Trewey

Cockernee, Pasty munchin bastid.

Posts

20,088

Location

Kernow - Near England

• Apr 24, 2009

• #4

Box of matches - 10p.
Gallon of petrol - £5.
Comprehensive insurance - priceless.

 

M

Mr Anderson

New Member

Posts

19

• Apr 27, 2009

• #5

cost me about 300 in all, we did it ourselves

get a haynes manual, and start ordering off ebay

also took the opportunity to do the water pump and timing belt while we were there, but these jobs were far from easy in comparison to the head gasket, that was more time consuming than difficult

 

M

mjltigger

New Member

Posts

1,890

Location

Trowbridge, Wiltshire...

• Apr 27, 2009

• #6

piston burn out.. as in a hole in the piston.. meaning you need a new piston.. and that means pulling the bottom end to get it out... ouch...

£800 doesn't sound too bad from a decent garage but you could probably shop around and get it cheaper.. or do it yourself.. be prepared for a seized bolt ruining your month and you'll be fine...

 

chromiumuk

Well-Known Member

Posts

2,203

Location

Earth

• Apr 28, 2009

• #7

Mr Anderson said:

cost me about 300 in all, we did it ourselves

get a haynes manual, and start ordering off ebay

also took the opportunity to do the water pump and timing belt while we were there, but these jobs were far from easy in comparison to the head gasket, that was more time consuming than difficult

Click to expand...

Might be better to get the gasket from a specialist to make sure you get the upgraded one. I believe a lot of the older crap is being flogged off through ebay.