P38A grease nipple on rear prop and o ring on pipe from top heater pipe

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
J

Jerseyp38

Active Member
Posts
240
Hi All,

Sorry to trouble but since she is running so well have started tackling the other little jobs: All oils changed, inc steering pump, hot start fix removed and went to grease the shafts and UJs.

Did a couple but gave up and have ordered a flexible connector for the grease gun but also the grease nipple was missing from the rear prop shaft and in a state of laziness could anyone tell me what grease nipple is needed? M6?

Also there is just a film of moisture on the front of the engine which I think is coming from the heater pipe that goes around the thermostat housing so assume I must have fitted the incorrect size of o ring when I changed the thermostat. So does anyone know what the dimensions are for that o-ring? P483 in RAVE item 11?

Thanks in advance.

Will be giving it a wash and polish next!
 
I'm guessing it's a diesel,if so prepare for a shock.
 

Attachments

  • 20190618_201643.jpg
    20190618_201643.jpg
    108.2 KB · Views: 165
Sorry, yes, diesel, 95, manual. I would pop under and try an m6 bolt in the hole but kids end of term show all week so no time, plus every time I get under the car the Mrs assumes it is something really bad!
 
tomcat59alan said:
I'm guessing it's a diesel,if so prepare for a shock.
Click to expand...
1

Haha, was wondering what the shock was going to be then looked at your photo! Unfortunately quite use to it! I guess as long as it is the correct o ring???? Was hoping one of the set I have might have fitted..........
 
If you push the ball in the grease nipple in with something like a bradawl to make sure it isn't jammed it helps.

I'm sure I had a spare grease nipple from a UJ in my shed. Cannot remember when I last saw it but could have a dig around for you?
 
If you push the ball in the grease nipple in with something like a bradawl to make sure it isn't jammed it helps.

I'm sure I had a spare grease nipple from a UJ in my shed. Cannot remember when I last saw it but could have a dig around for you?
 
wammers said:
Grease nipples are UNF threads NOT metric. https://rimmerbros.com/Item--i-TYL100030
Click to expand...

Makes sense for it to be a fine thread.

Did thin about taking one out but happy to wait a week and just have one in there. Especially with a fine thread, way to easy to muck up!

Just trying to find a place with sensible delivery charges, might even have to be the main dealer and cannot say stealer as there are no delivery charges!

thanks for the replies, very helpful and I can climb under the car when the Mrs is not around!
 
I find you have to grind a couple of flats on the grease gun to fit it in the UJs to get the grease into the joints otherwise the gun will not fit on to the nipples properly
 
You must log in or register to reply here.

Similar threads

A
P38A Heater matrix o-ring / pipes - advice needed !
2
Replies
24
Views
3K
P38 Monkey
P38 Monkey
P
Disco 4 Crossover pipe blowing
Replies
17
Views
3K
Graculus
Graculus
D
D2 new front prop shaft and grease question
Replies
4
Views
1K
Disco Magic
D
S
Disco 3 (LR3) Vibration on acceleration and cruising
Replies
9
Views
2K
SM1543
S
D
oil cooler pipe passenger side
Replies
0
Views
976
davethebuilder
D
Back
Top