Give us a clue Britpart

cornish rattler

Well-Known Member

Posts

6,432

Location

Manc chester

• Jun 5, 2019

• #1

Hi guys
Got a BP Petrol / Diesel fuel sender from Paddocks to fit to my ex Petrol 2a swb now converted to 200tdi and when I opened the box to fit the sender I found it was in 2 pieces the sender with a bar fitted to it but without the float fitted, a straight bar with a float fitted but not shaped at the sender end and can't work out how to fit it and in the pic I placed my old petrol sender as well, any idea's please as i'm a bit

 

minecab

Active Member

Posts

156

Location

milton keynes

• Jun 6, 2019

• #2

place both bits together to the same dimensions as the old unit, then solder them together. you should have got several very small clips with the sender to clip the two parts together but I find it better to solder them

 

R

Rodeo Joe

Well-Known Member

Posts

1,578

Location

Uk

• Jun 6, 2019

• #3

I used loads if tiny cable ties to hold mine together cos the small clips fell off and I ran out of diesel.

 

R

rob1miles

Well-Known Member

Posts

3,565

Location

Slough and Bath

• Jun 6, 2019

• #4

I use the brass centre bits out of cable connectors, the things with 2 screws in, then you can adjust until its right.

 

cornish rattler

Well-Known Member

Posts

6,432

Location

Manc chester

• Jun 6, 2019

• #5

Are right now i understand, mite go with rob's idea as i've got loads of them Chocblocks conectors