Fuel Pressure Regulator leak

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discochimp

discochimp

New Member
Posts
52
Location
Flintshire
HI Disco Fans

Can some one help please. I have a leak on my td5's (FPR):( I have been looking around to see what can be done. On ebay you can get kit of O rings and a gasket to fix the existing reg, has any one done this and was it an easy job.

Thanks
 
Ye I need the two pipes, been looking today at price for the part and done some research on this subject, Not sure but might get a rebuild kit for it and take a chance
 
Hi, i bought a repair kit from ebay a couple of weeks ago and replaced the regulator and with new gasket, o ring. Was fiddly job and a few sware words were used but got there in the end and fingers crossed its still all ok.
 
micknkatenki said:
Hi, i bought a repair kit from ebay a couple of weeks ago and replaced the regulator and with new gasket, o ring. Was fiddly job and a few sware words were used but got there in the end and fingers crossed its still all ok.
Click to expand...


Was it an easy job getting the regulator out and how easy was it to get the new one in do you have any Problems with the circlip back.
 
On fourth incarnation, first one leaked, tried the O rings, no joy, replaced with second hand one which lasted a few months and lost pressure but didn’t leak. Bought just the regulator bit off Ebay which seems to be working OK ish. Circlip goes in OK with careful use of screwdriver or correct tool ! Put an elastic band around the regulator body and gasket to hold the latter in place as you get the bolts engaged. Then just cut it and retrieve the bits. All needs to be done as you lie over the engine from the nearside with a quarter inch socket set and a slave underneath to retrieve the bits you drop.
 
Thanks for the reply it's good to hear that some one has done the regulator and it worked out. I see that people have bought the kit, its a shame that we don't get to hear how they got on fitting it
Good tip elastic bands
Thanks
 
Hi, remove the engine cover, remove the engine lifting eye, remove tue electic plug, remove the 2 pipes which are quick release, undo the 3 bolts and remove the pressure regulator, remove old gaskit, be very carefull and remove the o-ring which then lets the small filter slide out, clean filter and replace - i used a small bit of grease to hold it in place, refit new o-ring again with a small bit of grease to hold it in place, put regulator in a vice very carefully, remove circlip with circlip pliers, use a pair of pipe pliers to carfully remove old regulator, clean houseing well and replace with new regulator which just pushes in, refit circlip, put a thin smear of gasket sealer on new gasket to hold it in place while refitting the fuel pressure regulator, refit as you have removed it, turn on then off ignition 2 or 3 times to bleed fuel system, start vehicle and check for leaks, road test and recheck. All done, job done.
 
You must log in or register to reply here.

Similar threads

E
Disco 2 Fuel Leak
Replies
1
Views
617
Landmark2
Landmark2
mad85
Disco 2 TD5 Low Fuel pressure!!
2
Replies
22
Views
3K
mad85
mad85
P
fuel pressure regulator???
Replies
2
Views
435
Pigglet
P
V
FPR leak on startup following new cylinder head
Replies
2
Views
457
versteckt
V
L
Fuel pressure regulator
Replies
2
Views
1K
lawr.i.e
L
Back
Top