Fixed my squeek, still squeeking!

RyanP · Jan 16, 2009

Hello peeps, i asked last week about my really loud chirping/squeeking(which started after i washed the engine bay) and i ended up buying a aux drive belt tensioner repair kit (bearings and snap ring) from e bay. I was so convinced that it would stop the noise but it hasn't!!!! The noise is exactly the same. I did exactly as it said on the instructions and now i really am stuck. My brother/assistant questioned whether i should have used grease on fitting the new bearing but it didn't say on the instructions so i didn't ?

I drove it a couple miles, came home and sprayed wd40 on the tensioner pulley and as before it stops the squeek for a few seconds and it starts up again.

Anyone got any ideas, please

lerk · Jan 16, 2009

did you leave the penny in?

nickh75 · Jan 16, 2009

are you sure it's the tensioner?

could be alternator, water pump or power steering pump.

mine went after i replaced the alternator

then the water pump fooked up

just waiting for the p/s pump to blow now

300tdi · Jan 16, 2009

I know it is probably irrelevant to this thread but...

RyanP said:
came home and sprayed wd40 on the tensioner pulley

If I'm not wrong, isn't WD40 a degreasing agent? Thus it would wash out the maufacturers grease from bearings and alike?

RyanP · Jan 17, 2009

No, i didn't put the penny back in. I'll give that a try later. I did put a couple drops of 3in1 oil on the smooth face of the tensioner pulley last night, and the noise changed ???

discobill · Jan 17, 2009

South Devon Fishing said:
If I'm not wrong, isn't WD40 a degreasing agent? Thus it would wash out the maufacturers grease from bearings and alike?

WD40..tis a water dispersant and light oil.

heggars · Jan 17, 2009

Had/got this problem on my mates 300TDi, changed the Alt as the bearing had just about gone, changed the water pump and tensioner, has bought 2 new aux belts and it's still there.

Well this morning we put the other belt on which is 15mm longer, and was a lot easier to get on, didn't have to use a pry bar on the spanner to loosen the tensioner

Went for a test drive and stopped it, unless you went over 2K and it was very faint so just waiting for the belt to settle in........ lets see what happens

Stu

Fixed my squeek, still squeeking!

RyanP

Member

lerk

New Member

nickh75

Well-Known Member

300tdi

New Member

RyanP

Member

discobill

Active Member

heggars

Nec flectitur nec mutant

Similar threads