bikerguy34
Member
- Posts
- 33
- Location
- Christchurch NZ
Somtimes get 'F4' code appearing upon start-up. Stop car, wait a few secs, start and its gone!. Anyone any idea what this code relates to?
Fault code 'F4'
- Thread starter bikerguy34
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
bikerguy34
Member
- Posts
- 33
- Location
- Christchurch NZ
hill descent light is also flashing the small red led to right of gear lever (i.e. sport light also comes on -even tho it is in park). I'm assuming it is an electrical system connected to the gearbox. Mine still does this sometimes have to ignition on/off 4-5 times to reset now tho!
Its getting worse but on average only happens every 2-3wks
Its getting worse but on average only happens every 2-3wks
megreg
New Member
- Posts
- 4
- Location
- Knockemstiff, Ohio USA
I have the same thing goin on with the wife's 2004 Freelenader 2.5 V6. Best I can tell, the F4 just says the computer is storing fault codes in memory. I have found several different codes stored on separate instances of the F4 being displayed. You have to have a modern OBD2 scanner with vehicle specific code ability to read them.
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
F4 means the gearbox TCM (Transmission Control Module) has implemented its limited operating strategy (commonly called limp mode). This means the gearbox will be locked in 4th gear only (reverse is normally still available). The only way to find the cause, is to have the TCM codes read, by someone with a suitable code reader.
kernowsvenski
Well-Known Member
- Posts
- 1,476
- Location
- Truro
I had an F4 fault a few years ago which disappeared after making sure the barrel connector was secure.
Hippo
Lord Hippo
- Posts
- 51,895
This is an old fred at 12+ years. There's many other newer freds on ere that cover F4 flashing and the causes. If you have a search you will find them.
Checking the barrel connectors are secure and measuring the resistances as per the video below is the first step to investigate F4 flashing problems:
resistance video = https://www.youtube.com/watch?v=VTmdkDuKZ6A
Checking the barrel connectors are secure and measuring the resistances as per the video below is the first step to investigate F4 flashing problems:
resistance video = https://www.youtube.com/watch?v=VTmdkDuKZ6A
