sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
Gents have an exhaust manifold bold sheared of flush with the head tried a carbide drill bit but no good it doesnt want to play any ideas?
Exhaust manifold bolt bust
- Thread starter sandyt
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,274
- Location
- Gloucestercotshirewolds
If its flush it should be possible to carefully weld a nut to it, the heat will help as well so long as you dont melt the head!
sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
Sorry my fault its not flush as such I meant not protruding its causing a prob with exhaust manifold letting air in to lambdas so need to get it fixed I am working in Evesham so will have to have a trawl through tinternet. I did look at getting a nut on it but not pos well not for me 
- Posts
- 58,170
- Location
- Preston Lancs.
Studs should not be that hard, although they do work harden over time. If you used a proper carbide drill and you can't cut it with that, you ain't going to cut it with anything. Very sharp drill bit slow and lots of pressure is the way to drill hard objects. An electric drill is too fast and will just work harden the metal more. Get some C1150 drills for such jobs they are worth their weight in gold.
sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
Thanks wammers think it was operator error as it was late and I was tired will def get some C1150 drills and have another go
stopover
Active Member
- Posts
- 852
If you can get a drill to it and follow advice from Wammers you should be able to use a HeliCoil insert - just Google Helicoil
sandyt
Well-Known Member
- Posts
- 1,615
- Location
- Wraysbury Nr Heathrow
If I can get the stud out I will just clean up the thread and I have a load of timeserts ifneeded its getting the stud out that is the prob
Grit Valve
2000 4.6 Vouge
- Posts
- 12,465
- Location
- Plaistow
Try a cobalt drill but that will eat trough whatever the size bolt say 8mm drill a 7.5 hole and retap if no luck you can helicore as suggested.
- Posts
- 58,170
- Location
- Preston Lancs.
If he can't cut it with carbide he ain't going to touch it with cobalt. You need a pilot 3.2 or 4 mm before attempting with a tapping drill. Your 7.5 mm is a little on the large size anyway tapping drill for 8x1.25 is 6.8 as i recall.
Similar threads
