Engine Management Indicator

forestdave · Nov 14, 2010

Hi, Having my Freelander diagnosed as needing a replacement Fuel Pump after it failed to start and the Engine Malfunction light coming on, it now has a new Fuel Pump, starts first turn of the key, BUT the warning light stays on.
Do you have to reset them?
Do I have some other problem?
The new Pump is not a genuine Land Rover part, does this make any difference?
Any help would be appreciated
Dave

Fake Elvis · Nov 14, 2010

You need a fault code reader/clearing device to reset the MIL (warning light) quite expensive to buy to reset a light but may be cost effective in the long run...

forestdave · Nov 14, 2010

Thanks Fake Elvis,
But do you think it"s ok to drive my Freelander with this light on?
2000/2001 Freelander TD4S auto 110k.

Chaser · Nov 14, 2010

I think you might find another emissions related fault code. Once Lp fuel pressure has been restored the light should have gone off.

Mantamad · Nov 14, 2010

forestdave said:
Thanks Fake Elvis,
But do you think it"s ok to drive my Freelander with this light on?
2000/2001 Freelander TD4S auto 110k.

Due to the age of your TD4, its likely that one of the cheaper universal OBDII readers will not work on your Freelander - try to borrow one rather than buy.

Chaser said:
I think you might find another emissions related fault code. Once Lp fuel pressure has been restored the light should have gone off.

Good point, the light went off by itself on mine when I fitted the new pump.

forestdave · Nov 15, 2010

Thanks everybody.
Dave

Engine Management Indicator

forestdave

New Member

Fake Elvis

New Member

forestdave

New Member

Chaser

New Member

Mantamad

New Member

forestdave

New Member

Similar threads