Forgottenpoppy
Well-Known Member
- Posts
- 4,661
- Location
- Windsor
Seem to have squealing intermittently at front and its followed by it pulling right on steering then it goes, can't see any leaks of brake fluid. Any ideas?
Eek front end squeak
- Thread starter Forgottenpoppy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,205
- Location
- Gloucestercotshirewolds
Sticky caliper piston I 'spek but check the wheel bearings urgently
Forgottenpoppy
Well-Known Member
- Posts
- 4,661
- Location
- Windsor
Bearings just been done
Seems to have sorted itself but gonna get it checked just in case
Cheers BB
Forgottenpoppy
Well-Known Member
- Posts
- 4,661
- Location
- Windsor
Fluid level is good, auxiliary belt is good as far as I can tell, squeak is now slight and only really noticeable slowing down not under breaking, so far not had any more snagging on the steering
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
Fluid level is good, auxiliary belt is good as far as I can tell, squeak is now slight and only really noticeable slowing down not under breaking, so far not had any more snagging on the steering
id think it was a brake issue to if you have just had bearings done ,you will be able to tell if you remove pad retainers and grab pad with molegrips and lean it back against piston if pistons are good it will move
Forgottenpoppy
Well-Known Member
- Posts
- 4,661
- Location
- Windsor
Forgottenpoppy
Well-Known Member
- Posts
- 4,661
- Location
- Windsor
Turns out cv joint had no grease got so hot is causing the binding and has warped the break disc
