- Posts
- 2,101
- Location
- Mull of Kintyre
How do you get the collets in the valve block out?
P38A EAS silly question
- Thread starter oakey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
Normally they just pull out, but might need a little assistance with a flat bladed screwdriver each side to ease them out
this is assuming you have the pipes out already
this is assuming you have the pipes out already
- Posts
- 2,427
- Location
- Isle Sheppy
+1
- Posts
- 2,101
- Location
- Mull of Kintyre
Ok ta
Yes pipes are out and block is stripped
Yes pipes are out and block is stripped
brianp38dse
Well-Known Member
- Posts
- 20,093
- Location
- heathrow
I believe new ones are available if you have a little mishap getting them out.
- Posts
- 2,101
- Location
- Mull of Kintyre
Got the collets out ta and changed O rings but one of them is not lying flush, Taken O rings out and tried to reseat again but still no luck
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
that's what I didNormally they just pull out, but might need a little assistance with a flat bladed screwdriver each side to ease them out
this is assuming you have the pipes out already
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
get your crochet hook to fish them out and seat flat. if you've got something in progress on your crochet needles then something similar, I use my small allen key as it has a ball type end
- Posts
- 3,944
- Location
- Near Heathrow.
the blunt end of some 7 & 8mm drills work well for seating the o-rings.
- Posts
- 2,101
- Location
- Mull of Kintyre
Think I will put the old ones back in
