P38A EAS box

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

J L Carr

Active Member
Posts
360
Location
Hemel Hempsted
Hi Guys, could someone tell me sometime, on the side of the EAS box that holds the compressor and the valves there is a bunch of numbers, going from 1 to 11 what do the numbers correspond to. Just to make sure I have my air lines in the right place manly the 4 for the air bags. Thanks.
 
If you were to rotate the EAS box through 90 degrees so the lines are on top the 4 bag lines are in the same corners as they are on the car.
The problem I'm having at the moment is my drivers side rear keeps on going down, it's not the line or the air bag because I've just had the whole lot pumped up with the Schrader valves up to 55 cm to gain access to the tank to put the new pump in.the car never drop a lot only a couple of cm's but since putting the whole system back the car has completely dropped in the rear drivers side, that's why I wanted to know the numbers to make sure they are in the right place.
 
The problem I'm having at the moment is my drivers side rear keeps on going down, it's not the line or the air bag because I've just had the whole lot pumped up with the Schrader valves up to 55 cm to gain access to the tank to put the new pump in.the car never drop a lot only a couple of cm's but since putting the whole system back the car has completely dropped in the rear drivers side, that's why I wanted to know the numbers to make sure they are in the right place.
Are you sure there is not a leak where the pipe goes into the valve block? If the end of the pipe has been trimmed, the raised collar on the pipe may be stopping it going in far enough.
 
Well because of the link Tenebraux posted I had to change around the pipe works and up to know the car has stayed up and at the same height of 480 mm from arch to centre of the wheel, it has not dropped in any corner. Lets hope it stays that way, so I'll find out tomorrow fingers crossed. Thanks guys.
 
Just to give everyone an update about the suspension it stayed up at normal height for over 5 days then it started to drop just a little, so because the pipe work is now in the right order by the plan I had sent over it looks like all is ok up to now. Many Thanks for All your help.
 
Back
Top