P38A eas and axle stands

johnnysensi · Dec 30, 2015

Doing my upper and lower ball joints ...I've placed axle stands under axle ...just got my swivel hub carrier off after some trouble ...trouble is the air suspension has now lowered itself
...is there anyway of getting the eas to work on axle stands ?....now I can't get enough clearance to press the joints out ...or do I have to do it upside down lol .

wammers · Dec 30, 2015

johnnysensi said:
Doing my upper and lower ball joints ...I've placed axle stands under axle ...just got my swivel hub carrier off after some trouble ...trouble is the air suspension has now lowered itself
...is there anyway of getting the eas to work on axle stands ?....now I can't get enough clearance to press the joints out ...or do I have to do it upside down lol .

If you have one of the ball joint removal kits off eBay you should be able to do both from the bottom. Or start the car and send suspension up.

johnnysensi · Dec 30, 2015

Eas is throwing a hiss fit and won't move ....upside down it is then ....

Saint.V8 · Dec 30, 2015

Did you have a door open during the time the car lowered itself? If so, you have a leak....

Remember, when on axle stands and you are working under or near the car, leave a door open a crack to freeze the system.

johnnysensi · Dec 30, 2015

Doors were open ...was a good whack on hub carrier and it dropped eas....now on eas button I got lowest setting flashing and highest level flashing

johnnysensi · Dec 30, 2015

Got eas working ...we have lift off....

P38A eas and axle stands

johnnysensi

Active Member

wammers

No longer with us, RIP

johnnysensi

Active Member

Saint.V8

Dyed-in-the-wool 100% RR Junkie

johnnysensi

Active Member

johnnysensi

Active Member

Similar threads