Disco 2 Door wiring query

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
B

BigHero6

Member
Posts
11
Location
Huddersfield
Hello! Could anyone kindly assist please? (I’ve searched the site and read through similar problems but am still stuck! )

Our front passenger electric window has been working intermittently and has now stuck half way down. I can hear a click from BCU, the the wiring from the BCU towards the door appears in good condition. I’ve traced it to a transformer (?) block before it enters the door grommet and am a little flummoxed as to which wires I should now check. Does anyone please have a wiring diagram showing wire colours as they enter the door? Or do I need to take the door apart and work backwards? Many thanks in anticipation and apologies if a stupid question!
 
The only stupid questions are the ones you don't ask.

I have had intermittent trouble with the window in the driver's door which I finally traced to a broken wire inside the rubber tube grommet between the door and the door pillar. It's a point where the wiring is under mechanical stress.
I replaced the wire and I've had no trouble since.
The window regulator motor only has two wires, the connections to it are reversed in the Windows ECU to wind it up or down so identifying them will be easy once you have access. You will have to remove the door card and cut into the plastic water shedder membrane to get into the door to make your checks and any necessary repairs. Repair the plastic membrane with "Gaffer tape" or duct tape.
 
I had to fix the same problem with my driver's door. I recently changed the window regulator on the passenger door and because it was quite warm, the membrane peeled back nicely. The drivers door was done in colder weather and I had to use scissors and gaffer tape. Also the door fasteners came apart without any breaking on the warmer day.
 
Hello, apologies to restart this thread, does anyone know the voltage of the window motor please? Would I be able to direct feed it to get it moving? The wiring issues appears to be from the BCU and I’m not touching that! Thank you!
 
brian47 said:
The window motors are 12 volt devices. Connect the power one way to wind the window down and the other way round to wind the window up.
Click to expand...
Thanks so much! I connected it to my motorbike battery with jump cables and it’s now finally up hurrah! No more unintentional windswept looks. Thanks again.
 
You must log in or register to reply here.

Similar threads

StuRox
Disco 1 Interior Light door switch wiring
Replies
11
Views
685
GIlbert114
G
M
Central locking on passenger door
Replies
3
Views
387
Scooby22
Scooby22
W
Wolf-specific heated windscreen wiring question:
Replies
0
Views
918
Wolf Pack
W
Skihorn
Door Sill Trim Clips
Replies
8
Views
781
Skihorn
Skihorn
A
Freelander 2 (LR2) Tailgate opens when I open the driver door
Replies
2
Views
469
Nodge68
Nodge68
Back
Top