Door stay?

Quick one for someone...

Where does the bracket go for the rear door stay (safari type)
I currently have a chain setup and want to change it for a stay.
I have the stay but no bracket.

If anyone has pics, and could measure it for me it would be great!!

Am currently working on door cards, insulating and carpeting, will post pics when done.

Thanks
James

There's a channel at the bottom of the door on the hinge side that the stay fits into and is buffered by a rubber pad. The other end of the stay attaches to a bolt in the floor.

thanks boss, any chance of a measurement?

My rear door is under a pile of bits but it's in the parts book - you might be able to size it from there. They're only about a fiver each.

parts book in here if you need it...

pdf Land Rover Manuals | Landroverweb.com

I have the stay, its just the bracket or bolt location on the floor or bench side I need.
There is nothing in the manual about it./

Thanks

Fit the door and stay, open the door just past 90 degrees and drill the hole in the floor where the hole in the stay is, about 2cm out from the seat side. Use a 30 mm long bolt 10mm dia should fit, the order is, top to bottom, bolt, washer, stay, washer, nut, locknut (set to allow bolt to rotate in stay) large diameter washer, floor, large diameter washer, nylock nut.