Hi all, I am replacing the clutch on my 200 tdi in the next couple of weeks.
As I have been trying to locate a vibration from the transfer box area and whilst the transfer/gearbox are out I intend replacing the output shaft bearings front and rear to eleiminate them from the the list.
I have a good range of tools i.e. pullers/large vice ect but no other workshop facilities like a press, are they a diy job?
Thanks in advance
regards
Dave
As I have been trying to locate a vibration from the transfer box area and whilst the transfer/gearbox are out I intend replacing the output shaft bearings front and rear to eleiminate them from the the list.
I have a good range of tools i.e. pullers/large vice ect but no other workshop facilities like a press, are they a diy job?
Thanks in advance
regards
Dave