Distriutor Removal

I have recently added a 1991 Range Rover Classic to my fleet. I bought it from a Storage location that was selling it for fees due. It had been in storage for about 2 years.

The engine will turn over but will not start. I am currently attempting to remove the Distributor in order to remove and replace the Ignition Amplifier Modlule. I have followed the procedures in Rave 86 Electrical down through5. The next step is to "Release Distributor clamp". The picture does not show the location of this clamp. Where is it?

Thanks in advance for your help.

Clamp is where the distributor enters the engine block.

I finally see it! It is more specifically located beneath the Ignition Amplifier Module, the part that I need to remove. Now I have to figure out how to bet to it and with what. Surely, there was another way to design this. Now I understand why the info on it's location is so sketchy.

Thank for your help.