Discovery 94 200tdi Slave Cylinder

Gunny · Jan 16, 2013

I ordered from the bay a slave cylinder for my 1994 200tdi discovery, it arrived today my question is what length should the cylinder be from the flat where you screw into to the front where the rubber bung goes over, I have measured and it appears to be just over 4 / 105cm

barmatt · Jan 16, 2013

sounds about right, what's the problem?

Gunny · Jan 16, 2013

It just seemed to be short

barmatt · Jan 16, 2013

are you sure you got the right one?

a 200tdi will have an lt77 gearbox and a 300 has an r380.

200 part no is ftc2498

300 part no is ftc5072r

did you specify was gearbox you had when ordering?

Gunny · Jan 16, 2013

just seen stamped on the side of the shalft LR 300

barmatt · Jan 16, 2013

Gunny said:
just seen stamped on the side of the shalft LR 300

If you'd told the supplier it was for a '94 disco they would have assumed it was a 300 as this is the year they started fitting 300's but they did make a few 200's aswell to add a little future confusion.

Just need to specify engine type in future.

What's the part no on the box?

Discovery 94 200tdi Slave Cylinder

Gunny

New Member

barmatt

Well-Known Member

Gunny

New Member

barmatt

Well-Known Member

Gunny

New Member

barmatt

Well-Known Member

Similar threads