Discovery 2 top windscreen rubber
- Thread starter Domjw1993
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 9,105
- Location
- Roaming the UK on assignments
D2 has a bonded screen and that is a trim piece that should just prise out I think.
sierrafery
Well-Known Member
- Posts
- 17,910
- Location
- Arad/Romania
That windscreen finisher is not reusable once bent as it has a soft metal insertion but it acts as a seal too so if you can't be so carefull to remove it without bending it better buy a new one or the whole thing will look like sh*t, not very expensive but not cheap either DCB101510
https://www.landyzone.co.uk/land-rover/getting-rid-of-roof-rust-spots.292210/
I done mine a few years ago. I had a cracked windscreen and done the roof when it was out. The top rubber was fitted new along with the screen by the installer.
I done mine a few years ago. I had a cracked windscreen and done the roof when it was out. The top rubber was fitted new along with the screen by the installer.
- Posts
- 45,055
- Location
- East Dorset
Mine wasn't quite as bad as that, I just treated the rust as best I could then sealed it with professional silicone sealant. But if you can get the trim strip off, then fine, but what are you going to do it you find rustholes have pierced the metal? Thinks, "Take out screen 
, weld and grind back fill, paint, , put screen back in and hope it fits "
HMMMMMM!
, weld and grind back fill, paint, , put screen back in and hope it fits "HMMMMMM!
