Craigevo92
Member
- Posts
- 69
- Location
- Widnes
We also tryed plugging a nano com in for diagnostics and it couldn't get into the ecu is that because it is a 10p ecu and it wont read through the obd port ?
Discovery 2 stuck in inertia mode
- Thread starter Craigevo92
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
sierrafery
Well-Known Member
- Posts
- 17,164
- Location
- Arad/Romania
No, nanocom should read everything unless the vehicle is immobilised.
- Posts
- 2,096
- Location
- East of England, UK
did you get to the bottom of it?
Kenbo
Active Member
- Posts
- 189
- Location
- Coleraine, Northern Ireland.
Old thread and he hasn't been on since. Typically these people get a lot of very good advice and don't have the courtesy to report back on the result.
Sierrafery: very impressed with "interpunction" I thought my grammar was pretty good but that was a new one to me.
Sierrafery: very impressed with "interpunction" I thought my grammar was pretty good but that was a new one to me.
- Posts
- 2,096
- Location
- East of England, UK
Quite annoying really, I’ve had a few problems and always make sure to conclude the posts.
Craigevo92
Member
- Posts
- 69
- Location
- Widnes
Hi sorry haven't been getting emails to say people have replied yes it turnt out to be a bad engine bay fuse board replaced and all was fine thanks
