Disco1 cruise control

Abbott · Aug 2, 2018

Hi all got disco 1 cruise control being a bit off have replaced all vacuum pipes had multi meter on ecu terminal good continuity on ground pin battery voltage on main supply same on secondary supply battery voltage from brake pedal pin set pin and decrease pin approx 9 to 9.8 volts from vss pin jumped pins for vac pump bellows contract and release as voltage applied and removed. Finger over vac pipe with bellows compressed push brake bellows release. Changed ecu still don't work! Any ideas anyone driving me mad and refused to be beaten by inanimate object!!!!!

kevstar · Aug 2, 2018

Nope no idea welcome to Lz though

Hippo · Aug 4, 2018

Welcome to the forum.

This section is for introductions only. Pop over to the disco section to ask for help fixing it.

Abbott · Aug 4, 2018

Hippo said:
Welcome to the forum.

This section is for introductions only. Pop over to the disco section to ask for help fixing it.

OK thanks new to this
Kind regards

Hippo · Aug 4, 2018

Abbott said:
OK thanks new to this
Kind regards

Dont worry. Some have been around on ere for years and still haven't got the hang of it. They're a bit shall we say "rough" in the disco section, but at least most of them are warm blooded.

Abbott · Aug 11, 2018

Hi you have to be when you have a disco 1 I am sure they are alive!!!

Disco1 cruise control

Abbott

New Member

kevstar

Well-Known Member

Hippo

Lord Hippo

Abbott

New Member

Hippo

Lord Hippo

Abbott

New Member

Similar threads