[email protected]
Active Member
- Posts
- 125
Hi all, can the ride hieght sensors be replaced on a disco 2 without the need for recalibration, if so, how so 
disco 2 ride hieght sensors
- Thread starter [email protected]
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Urban Panzer
New Member
- Posts
- 610
- Location
- Beds, UK
Yes they can, get the vehicle parked on LEVEL ground and make sure its run long enough to sit at "normal" height, then disconnect the battery (REMEMBER radio code).
Unplug and unbolt the old sensors, fit the new ones, and then re-connect the battery. Start the car and with ALL doors closed check she sits level, use the "offroad" switch to raise and lower the rear a few times, and all should be good.
Unplug and unbolt the old sensors, fit the new ones, and then re-connect the battery. Start the car and with ALL doors closed check she sits level, use the "offroad" switch to raise and lower the rear a few times, and all should be good.
sierrafery
Well-Known Member
- Posts
- 17,905
- Location
- Arad/Romania
......can be replaced but without recalibration they might not work properly.......first af all change them and U will see
Last edited:
[email protected]
Active Member
- Posts
- 125
is that the earth on the battery or both ?
Urban Panzer
New Member
- Posts
- 610
- Location
- Beds, UK
Earth will do.......
[email protected]
Active Member
- Posts
- 125
Cool
