Disco 2 disco 2 - 3 amigos still

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

vilguy

Do'er of stuff and the like
Posts
9,915
Location
Dumfrieshire
Ive got the nanocom on the disco 2 and originally it came up with shuttle valve fault, so ive replaced that...

then a rear ride sensor went so ive replaced that.

Theres now no fault codes showing on the nanocom but the 3 amigos are still on.... RAAAHHHH
 
I replaced the shuttle valve switch pack and installed the wires for the mod on it, but didn't connect them to the other end as the fault code disappeared.

If it was an abs sensor this should be picked up on the nanocom shouldn't it?

I've driven it a few miles but not all that far.

Re the ecu - it does sometimes throw a wobbly and the nanocom says it can't talk to it. Then after a few attempts it tends to sort it's life out.
 
Ive taken it out for a few jolly jaunts and still the amigos are on, and the nanocom is not picking up any fault codes from them.

It is picking up a fault with the new height sensor. It says its still not working (but it seems to work fine?!) could be a dodgy wire I guess.

Any suggestions as to the amigos as its not got any codes showing otherwise?
 
ive just thought, am I being retarded and interpreting the code wrong... rear r/h sensor could be the abs sensor and not the height... DOH!!
 
You could try disconnecting the other side and seeing if you get a similar fault code. Or even disconnecting the one you think is wrong.
They are on a plug so can be unplugged easy enough.


Cheers
 
Back
Top