diff input bearing

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
H

hilly1

New Member
Posts
55
Location
peterborough
Would have to happen wouldn't it just when I tax it :doh:
Not sure its called but I think its the input bearing (using the search function) but I got underneath the disco and the prop has about 1-2 mm of play in it where it goes into the diff. Is this ok or is it best to change it? If I need to change it can anyone tell me where I can get the bearing from and would I need anything buy anything else to get the job done.
Its a 1997, 300tdi disco.
Many thanks,
Mark.
 
I got the bearing from my local independent LR specialist.
If you're sure the play is in the bearing, and not elsewhere, then yes it needs replacing.
 
Thank you. I will call into Marshall's and hope I can explain what I need ok.
I may as well replace it then for peace of mind if anything else.
 
The part no of the bearing is 539707.
There are a few versions of the oil seal, dependent on chassis number, but I'd guess yours is FTC5258.
 
Right been under the disco and taken off the front prop and to my horror the bolt that holds the flange into the front axle was loose.
I have done it up to test it and all the play has gone.
If I took the bolt out, cleaned it and put some lock on it and did it up would it be ok does anyone think?
What is the torque setting on this bolt?
Many thanks,
Mark.
 
You must log in or register to reply here.

Similar threads

B
3 bolt flange Diff
Replies
1
Views
361
miktdish
miktdish
Sieklo
Disco 2 TD5 auto to manual conversion
Replies
3
Views
207
jamesDiscoTD5
jamesDiscoTD5
J
Engine mounts
Replies
4
Views
246
sierrafery
sierrafery
N
Discovery propshaft seal
Replies
10
Views
947
kevstar
kevstar
H
Base idle tuning - Disco 1 - V8 3.9L
Replies
5
Views
374
discool
discool
Back
Top