dent in front bumper

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

micky22

New Member
Posts
161
my p38 range rover had a small dent and a couple of tiny hole on the front nearside corner. is there anyway or any kind of filler i can use to fill it as i am going to colour code the bumpers anyway so it will not matter if the filler is not the same colour as the bumper and i dont want to go to the expense of replacing it if i can help it so i am open to ideas folks

cheers mick
 
That stuff will do you...maybe bridge the holes with some alloy mesh or even alloy sheet snipped from an old coke can with some nail scissors - using the filler as your glue...rough up the underside to give it a key.
 
my p38 range rover had a small dent and a couple of tiny hole on the front nearside corner. is there anyway or any kind of filler i can use to fill it as i am going to colour code the bumpers anyway so it will not matter if the filler is not the same colour as the bumper and i dont want to go to the expense of replacing it if i can help it so i am open to ideas folks

cheers mick
you could use fiberglass sound harder then it is.. get the bumper off rebuild from the inside and let dry filler the front rub down and paint. coke can will do the job:D but this will last abit longer
 
Bumper is thin plastic over steel.
agen im not 100% but i think you can split the plastic form the steel. when i upgraded my exhaust i had the back bumper off i think the plastic is just a skin when i got that off.. the steel bit stayed on the car so i think you could rebuild. but id just find a cheep replacement bumper
 
Last edited:
Back
Top