Dash bulkhead fixings

Morning all,

I'm trying to source the plastic insert/grommet nuts that push into the bulkhead for screwing/fixing the dash.

I've got some of the larger ones that run along the top edge, but there are also smaller ones located on the face of the bulkhead, approx 6mm square.

The bulkhead is a replacement Shielder bulkhead, which has caused problems up until this point, but hopefully these aren't errors too.

The only part number I can find is RTC3745, but can't clarify if these are the larger or smaller type.

Any help appreciated.

Trawling ebay listing eventually led to one that described RTC3745 as fitting a 6mm x 6mm hole. Perfect.

Are these the ones. Got these from Paddocks.

i have used polydoh mouldable plastic to make a few for mine,
the stuff is great in any toolbox,

Thanks Doc, that confirms the size. I've got some on the way from eBay, just waiting on the dash to come back now.

Rynner, I've not heard of that before... Will investigate.