D90 TD5 ABS 30 amp Fuse Blowing during Nanocom Bleed Test

Hello,

My 3 amigos decided to visit yesterday. I hooked up my nanocom and have the error code "13-04 pump failure 2" appear. I cleared the error and and the 3 amigos were gone for a few minutes only to return.

I decided to do a Bleed test with the nanocom and now it is blowing the ABS 30 amp fuse.

Has anyone experienced this, any ideas on where to go next? Maybe the pump 2 is stuck and thus causing the fuse to blow??

No help out there??

It is the "Fusible link 4 - ABS Pump relay (30A)" that keeps blowing.

Possible short? Possible bad modulator? Ideas are welcome

So, issued resolved and wanted to post problem and solution in case anyone ever has the issue. The motor on the ABS was causing resistance and blowing the fuse due to the bearing failure. When you pull the motor off the actuator there is a 22x8x7mm bearing that ocelates thus pushing the right and left pumps. This bearing basically fell apart and caused the motor to seize. New $5 Tiken bearing and all good with no 3 amigos or blown ABS fusible link.