Custom prop Salisbury axle

1976landrover · Jan 26, 2011

Hi I have to replace my rear prop fixed to my rear salsbury axle anyone know a engineering company that shortens props. I also run parabolics so prop conplains because of slight lift. Need help fellas before it gives up the ghost

jamesmartin · Jan 26, 2011

most small engineering firms can do them ,only need angle grinder to cut weld were tube meets yoke and a welder to rejoin ,if its done square it wont need balancing,or at least i have never had to

pornstarmax · Jan 26, 2011

jamesmartin said:
most small engineering firms can do them ,only need angle grinder to cut weld were tube meets yoke and a welder to rejoin ,if its done square it wont need balancing,or at least i have never had to

Even better find someone with a WEDM machine (wire electro discharge) they can trim off effing accurate.... with that!!!!

Get stuck PM me I can suggest if you let me know where you are!

Also may I ask if you could post a couple of pictures of axle with mounts moved - I'm doing this @ weekend!!!!

Ta

MX

blue beasty · Jan 27, 2011

do you really need to replace the prop or is it just the UJ's? You can get wide angle yokes but with the amount of lift from fitting paras you really shouldn't need them but if you have worn UJ's you will notice them more after a tweak upwards

nrgserv · Jan 27, 2011

THE PROPSHAFT CLINIC LTD, BRADFORD, WEST YORKSHIRE, UNIT 4 CROWN WORKS, PARRY LANE

link to propshaft clinic, bradford. would recomend.
however, it seems they've either moved or gone bump.

tottot · Jan 27, 2011

You can fit wedges between axle and springs to lift the nose of the diff and improve uj angle.

Custom prop Salisbury axle

1976landrover

New Member

jamesmartin

Well-Known Member

pornstarmax

Active Member

blue beasty

Leaks an prone to bits dropping off

nrgserv

Well-Known Member

tottot

Well-Known Member

Similar threads