kindwarf
Active Member
- Posts
- 109
- Location
- West Yorkshire
What the best way to cure this engine out or gear box, and any thing awkward to look out for.
regards.
regards.
Crank shaft oil seal rear
- Thread starter kindwarf
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 61,306
- Location
- Gloucestercotshirewolds
Personal preference really, I've always gone for box out.
It's straight forwards enough though it's a big seal to press in so you need to be careful to get it in square.
Don't skimp and get a cheap one and give the clutch and release arm etc a good check over and replace anything that's even slightly suspect while you're there.
You won't believe how upsetting it is to have the release bearing give out 2 weeks later!
It's straight forwards enough though it's a big seal to press in so you need to be careful to get it in square.
Don't skimp and get a cheap one and give the clutch and release arm etc a good check over and replace anything that's even slightly suspect while you're there.
You won't believe how upsetting it is to have the release bearing give out 2 weeks later!
kindwarf
Active Member
- Posts
- 109
- Location
- West Yorkshire
Forgot to say its an autoPersonal preference really, I've always gone for box out.
It's straight forwards enough though it's a big seal to press in so you need to be careful to get it in square.
Don't skimp and get a cheap one and give the clutch and release arm etc a good check over and replace anything that's even slightly suspect while you're there.
You won't believe how upsetting it is to have the release bearing give out 2 weeks later!
Similar threads
