Copper banjo washers

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I used the old washers when i did my engine change and its difficult to start 1st thing in the morning so i'm looking to change them and the injector washers too.

Cheers James ;)
 
unless they are leaking diesel out then there not an issue ,injector washers will show leakage if you squirt some water or thin oil etc around there locating holes ,id be looking for air getting in wet around leak off pipes or filter,lift pump back
 
sp00k said:
They look the biz. Do you know what sizes are required for fuel leak off washers and injectors? I have a small but persistent leak on one of the fuel leak offs. I think I might have a tiny leak on one injector.
Click to expand...
just buy some err1304 washers and a length of new 3mm rubber leak off pipe
 
flatlander said:
I seem to remember that you heat them to red, then quench - opposite to steel.
Click to expand...

Copper can be annealed either way.

When it's heated though, it's a good thing to keep the heat for a short while, a couple of minutes or more, before quenching in air (slowly) or water. Allows it all to normalise ...
 
Hi daz , I have leak off washers and injector washers if you need some mate. I just changed all mine and got a pack of 20 :)
 
You must log in or register to reply here.

Similar threads

marksman
Are Dowty / bonded seals Fuel resistant ?
Replies
9
Views
2K
lynall
L
S
Power steering pipes
Replies
3
Views
1K
chrisstdt
chrisstdt
A
STC1557 Gasket Set
Replies
1
Views
603
Anaconda
A
El-Ekim
Double banjo in fuel filter for diesel heater ?
Replies
9
Views
1K
landowner
landowner
H
Pipe airbox
Replies
1
Views
300
andyfreelandy
andyfreelandy
Back
Top